Shell Scripts

You can easily add healthcheck Flip ID monitoring to a shell script. All you have to do is make a HTTP request at an appropriate place in the script. curl and wget are two common command line HTTP clients you can use.

# Sends a HTTP GET request with curl:
curl -m 10 --retry 5 https://healthchecks-staging.flip.id/ping/your-uuid-here

# Silent version (no stdout/stderr output unless curl hits an error):
curl -fsS -m 10 --retry 5 -o /dev/null https://healthchecks-staging.flip.id/ping/your-uuid-here

Here's what each curl parameter does:

-m <seconds>

Maximum time in seconds that you allow the whole operation to take.

--retry <num>

If a HTTP request fails, retry up to this many times. By default, curl uses an increasing delay between each retry (1s, 2s, 4s, 8s, ...). See also --retry-delay.

-f, --fail

Makes curl treat non-200 responses as errors.

-s, --silent

Silent or quiet mode. Hides the progress meter, but also hides error messages.

-S, --show-error

Re-enables error messages when -s is used.

-o /dev/null

Redirect curl's stdout to /dev/null (error messages still go to stderr).

Signalling Failure from Shell Scripts

You can append /fail to any ping URL and use the resulting URL to actively signal a failure. The following example:

• runs /usr/bin/certbot renew
• if the certbot command is successful (exit code 0), sends HTTP GET to https://healthchecks-staging.flip.id/ping/your-uuid-here
• otherwise, sends HTTP GET to https://healthchecks-staging.flip.id/ping/your-uuid-here/fail

#!/bin/sh

# Payload here:
/usr/bin/certbot renew
# Ping healthcheck Flip ID
curl -m 10 --retry 5 "https://healthchecks-staging.flip.id/ping/your-uuid-here$([ $? -ne 0 ] && echo -n /fail)"

Logging Command Output

When pinging with HTTP POST, you can put extra diagnostic information in request body. If the request body looks like a valid UTF-8 string, healthcheck Flip ID will accept and store first 10KB of the request body.

In the below example, certbot's output is captured and submitted via HTTP POST:

#!/bin/sh

m=$(/usr/bin/certbot renew 2>&1)
curl -fsS -m 10 --retry 5 --data-raw "$m" https://healthchecks-staging.flip.id/ping/your-uuid-here

Auto-provisioning New Checks

This example uses healthcheck Flip ID Management API to create a check "on the fly" (if it does not already exist) and to retrieve its ping URL. Using this technique, you can write services that automatically register with healthcheck Flip ID the first time they run.

#!/bin/bash

API_KEY=your-api-key-here

# Check's parameters. This example uses system's hostname for check's name.
PAYLOAD='{"name": "'`hostname`'", "timeout": 60, "grace": 60, "unique": ["name"]}'

# Create the check if it does not exist.
# Grab the ping_url from JSON response using the jq utility:
URL=`curl -s https://healthchecks-staging.flip.id/api/v1/checks/  -H "X-Api-Key: $API_KEY" -d "$PAYLOAD"  | jq -r .ping_url`

# Finally, send a ping:
curl -m 10 --retry 5 $URL